fortic
Fast Reheat Option
Fortic combination units can be specified
with Supercal or Ultracal coils on request
for faster reheat.
Cold Section
The correct height for fitting the float
operated valve (Ball valve) and warning
pipe connection (overflow) is marked on
the cisterns of all units.
All units are supplied with a rigid type lid
which closely fits the rolled rim of the
cistern.
An overflow, frost guard and air vent kit complete with corrosion resistant mesh
screens are enclosed within the cold section for fitting on site.
These standard features ensure the unit fully complies both with BS 3198 and Water
Supply Byelaw 30 requirements.
The insulation of the division between hot and cold water sections ensures that heat
transference is minimal and it meets the requirement of the British Standard.
Cold water capacities are measured to the water level marking. Hot water capacities
are based on direct units.
Indirect units have marginally lower capacities due to displacement by the coil.
Connections
Units are normally fitted with three connections up to G1 female, a G1/2 draining
boss and a G2 1/4 immersion heater boss positioned as illustrated, however these can
be varied to suit user requirements. 22mm or 28mm integral compression
connections are available at extra cost on most units.
These Units are not included in the catalogue because an inhibitor cannot be used.
Therefore the system would not be Part L compliant. An alternative unit would be the
F10. However, units can still be supplied on a replacement basis.
- Complies with British Standard 3198
- CFC Free Insulation
- Fast Reheat Options Available
Direct - Fortic F1 Super Seven
Direct - Fortic F1
Indirect - Fortic F3
Indirect - Fortic F4
Indirect - Fortic F10
|
